Nolangroup N-Com MCS II Mode D'emploi page 12

EN
 Insert the microphone connector in the Basic Kit2 MCS.
 Before you place the speaker in its housing, apply the Velcro pad to the polystyrene cheek pad
(Fig. 16).
Fig. 15
Fig. 17
12
Fig. 16
 Position the loudspeaker in the special
housing obtained in the polystyrene cheek
pad (Fig. 17.
 Before you place the speaker in its housing,
apply the Velcro pad to the polystyrene
cheek pad (right side).
 Position the loudspeaker in its housing
obtained in the polystyrene cheek pad (right
side).
 Replace the polystyrene cheek pad (right
side), positioning the cable in the groove you
see in the cheek pad.