Quickie Krupton F Notice D'utilisation page 30

Pelvic restraint belt (continued)
When fastened check space between the pelvic restraint
belt and user. When correctly adjusted it should not be
possible to insert more than the flat of the hand between
the pelvic restraint belt and the user, (Fig. 6.15.7).
The lap belt should be fixed so that the belt sits at an
angle of 45 degrees across the user's pelvis. The user
should be upright and be as far back as possible in the
seat when correctly adjusted. The lap belt should not
allow the user to slip down in the seat.
(Fig. 6.15.8).
To fasten buckle:
Firmly push male buckle into female buckle, (Fig. 6.15.9).
To release buckle:
Press the RED button in the centre of the buckle then
pull the two halves gently apart, (Fig. 6.15.10).
NOTE: If you have any questions on the use and
operation of the pelvic restraint belt, the please contact
your wheelchair dealer, carer or attendant.
WARNINGS!
• The pelvic restraint belt must only be fitted or adjusted
by an approved Sunrise Medical dealer / agent.
• The lap belt must be checked on a daily basis to ensure
it is adjusted correctly and free from any obstruction or
adverse wear.
• Sunrise Medical does not recommend the
transportation of a person in a vehicle with the pelvic
restraint belt as a restraint system.
See the transit brochure from Sunrise Medical
for further information on transportation.
Maintenance:
Check lap belt and securing components at regular
intervals for any sign of fraying or damage. Depending
on usage, it may need to be replaced.
WARNING!
The pelvic restraint belt should be adjusted to suit the
end user as detailed above. Sunrise Medical also
recommends that the length and fit of the belt is checked
on a regular basis to reduce the risk of the end user
inadvertently re-adjusting the belt to an excessive length.
Krypton F
Fig. 6.15.7
Fig. 6.15.8
Fig. 6.15.9
Fig. 6.15.10
30 Rev.1.0