Technical Data; Notes On Safety; Symbols And Icons - Parkside PTBM 400 A1 Traduction Des Instructions D'origine

GB IE
31 Drill chuck key
32 Allen key
33 On/off switch for laser
34 Mounting screw, laser
D
35 V-belt
F
36 Spindle-side drive pulley
37 Motor side drive pulley
38 Interlock switch

Technical Data

Bench Pillar Drill ....... PTBM 400 A1
Rated input voltage U .......230 V~, 50 Hz
Idle power consumption P
Power input .............. 400 W (S6 40 %)*
Idling speed (n )
0
Spindle ......................600 - 2650 min
Motor ................................ 1400 min
Safety class .......................................... I
Protection category...........................IPX0
Weight (with accessories) ............ 13.3 kg
Drill chuck ...........B16 (1.5 mm to 13 mm)
Spindle stroke .............................. 50 mm
Workpiece size .................... max. 60 mm
Laser
Laser class ........................................ 2
Laser wavelength .....................650 nm
Laser power P ........................< 1 mW
0
Power supply
Laser module ..... 2 x 1.5 V Micro (AAA)
Sound pressure level
(L ) ................... 75.8 dB(A); K
pA
Sound power level (L
measured .......... 88.8 dB(A); K
* After an uninterrupted operating time of 4
minutes under load, the device must then cool
down for 6 minutes in idle mode, otherwise
overheating would occur.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
24
.....350 W (S1)
0
= 3 dB
pA
)
WA
= 3 dB
WA
The specifi ed noise emission value has
been measured according to a standar-
dised testing method and may be used for
comparison with another power tool.
The specifi ed noise emission value can
also be used for a provisional assessment
of the load.
Warning:
The noise emissions may deviate
from the specifi ed values during
actual use of the power tool, de-
pending on how the power tool is
being used and, in particular, what
kind of material is being worked
on.
Safety measures for protection of
the operator are to be determined
-1 that are based on an estimate of
-1 the load under the real operating
conditions.

Notes on safety

Caution! When using power tools,
observe the following basic safety
measures for the prevention of
electric shocks and the risk of injury
and fi re.
Please read all these instructions
before using this electric tool and
please keep the safety instructions.

Symbols and icons

Symbols on the device:
Warning!
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!