Programming Steam Wetness Or Steam Pump Rate; Factory Reset - Krups XP6180 Mode D'emploi

English
NOTE: When you have selected a new temperature setting the light above the button pressed lights up
and flashes and the machine makes 2 beeps.
The espresso machine will then automatically power on and begin heating up.

PROGRAMMING STEAM WETNESS OR STEAM PUMP RATE

The steam pump rate of this unit has been pre-set. Modifying the steam pump rate enables you to make
the steam wetter or dryer and aids in the delivery of a powerful, dry steam - ideal for frothing milk. The
steam pump rate can be modified in flow rate increments up or down should it be desired.
To do this you need to follow the instructions below:
Press and hold the "PROGRAM" button for 3 seconds. While still holding down the "PROGRAM"
button briefly press the "POWER" button and release.
Release the "PROGRAM" button.
NOTE: This light will remain on for up to 5 seconds before automatically returning to the factory setting if
no action is taken. The espresso machine will then power on and begin heating up.
Within 5 seconds, press and release one of the buttons below depending on the required temperature
adjustements:
NOTE: When you have selected a new pump rate setting the light above the button pressed lights up
and flashes and the machine makes 2 beeps.
The espresso machine will then automatically power on and begin heating up.

FACTORY RESET

To undo any changes made to the program you can revert back to the original factory settings. This resets
ALL the program settings back to factory settings, including the espresso and steam thermoblock
temperatures and the steam pump rate. To do this you will need to follow the instructions below.
Press and hold down the "MANUAL" button for 3 seconds
While still holding down the "MANUAL" button briefly press the "POWER" button and release.
Release "MANUAL" button.
NOTE: This resets ALL the program settings back to the factory settings
To indicate that you have successfully reset the factory settings, the light above the "POWER" button
will flash and 4 beeps will sound.
The espresso machine will then automatically power on and begin heating up.
18
+0.1 sec = press the "DOUBLE ESPRESSO" button
+0.2 sec = press the "PROGRAM" button
-0.1 sec = press the "MANUAL" button
-0.2 sec = press the "POWER" button