Description; Programming The Clock; Before Using For The First Time; Coffee Preparation - Krups SAVOY ISOTHERME ET352010 Mode D'emploi

1. DESCRIPTION

Appliance housing
A
Cover
B
Water tank
C
Water level gauge
D
Thermal jug lid
E
Thermal jug handle
F
Thermal jug
G
H Thermal jug lid lever
I Base
J Filter holder
ON/OFF button
K

2. PROGRAMMING THE CLOCK

■ Place the coffee maker on a flat, stable, heat and water resistant surface.
■ Plug the power cable into a 230V wall outlet.
1- When you plug in the coffee maker for the first time, "0:00" appears and blinks on the screen. Fig. 1.
Set the time by pressing on the H button (M) for the hours and MIN (N) for the minutes. The time
appears. It is automatically confirmed after 5 seconds have elapsed or by pressing on the
2- You can also set or modify the time at any other time. Set the time by pressing on the H button (m) for
the hours and MIN (N) for the minutes. The time is displayed. Fig. 2 and 3. It is automatically confirmed
after approximately 5 seconds have elapsed or by pressing on the
Please note: Your clock is now set and will continue to display the current time even when your appliance
is in standby mode.
If the appliance is unplugged or in the event of a power failure, the clock will reset to 0:00. Repeat the above
instructions to set the clock again.

3. BEFORE USING FOR THE FIRST TIME

■ Remove the stickers from the machine.
■ Prior to first use, run your coffee maker without any coffee to rinse the circuit. Fill the water tank up to the
maximum level and start a cycle by pressing on the bouton
IMPORTANT: Your appliance has been designed to operate using only cold or temperate water.

4. COFFEE PREPARATION

■ Lift the coffee maker's lid (B). Fig. 4.
■ Open the thermal jug lid by turning the lid until the arrow and the OPEN marking line up Fig. 5a.
■ Fill the thermal jug (G) with cold or warm water and reclose the lid by lining up the OPEN marking and the
arrow, and then turn the lid until the arrow is opposite the CLOSE marking Fig. 5b. Pour the water in the
water tank by pressing on the lever on the thermal jug lid to make the water flow. Fig. 6 and 7. The water
level gauge displays the number of cups. Do not exceed the max. level. Fig. 8.
■ Place the thermal jug (G) with its lid closed on the base (I) by ensuring that it is properly in place in order
to activate the mechanism that allows the coffee to flow. Fig. 11.
button
L PROGRAM
M H button
N MIN button
O AROMA button
P 1 - 4 cups button
Q CLEAN button (DESCALING function)
R Filter cartridge holder
S Filter cartridge
T Cartridge replacement indicator
U Spoon
(K).button .
(K).
(K) key.
7