Description of the appliance
Mist outlet (rotating)
Hydro Cell
Evaporation chamber
Water tank
A250 AQUA PRO
Water tank cap
Brush
Water base
Control panel
Main body
Water level sensor
Membrane
Power plug
Air inlet
Setting up
Finding the ideal location for your unit:
• Do not place the humidifier directly next to a heating
vent or on a floor with floor heating. The moisture of
the mist can damage the floor surface (6) (see Safety
Instructions).
• The unit should be placed in an elevated position (7),
e.g. on a table, chest, etc. at least 3 ft off the floor.
• The mist outlet must not be pointed directly at plants,
furniture, or other objects (13). Keep distance of at
least 20 inches (50 cm).
• Please refer to the enclosed manual for putting the
A250 AQUA PRO into operation.
• Read the instructions under «Filling the tank» for
adding water in the humidifier (14 and 15).
• Place the water tank onto the base.
• Insert the plug into the socket and switch on the
appliance using the on/off button (18).
• About 10 to 15 minutes after it is switched on the
device will reach its full output level.
• Make sure that the cable is not pinched anywhere (9).
Do not operate the humidifier if the cable is damaged
(2).
13
en
9