Feed Wheel Set Screws Tightening - Greenlee C3 Auto Whip Manuel D'instructions

Service (con't)
Feed Roller Set Screws Tightening Instructions
1. Turn off the C3 power.
2. Flip the C3 unit on its back to
expose the lower access panel.
3. Remove the lower access panel.
4. Locate the 2 set screws coupling the
drive roller to the shaft.
5. Re-tighten both set screws.
6. Re-install the access panel.
7. Flip the machine back into the
upright position
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
30
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070