Greenlee C3 Auto Whip Manuel D'instructions page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation (con't)
Figure 11
Note: Notch depth is the distance the notch cutting
blade will advance from its home position. See Cable
Reference Guide for approximate notch depth for
different diameter sizes of MC cable.
A total of 48 different cable types can be stored in
memory. Cable types can also be imported from the
USB port by touching the Import from USB box (see
instructions for Import from USB). The Load Selection
box enters the selected cable type into Operation
screen. The < will return to the previous screen. To
select the cable type, touch the Cable # box adjacent to
the desired cable type and press Load Selection. The
Cable # box will turn yellow and the Load Selection
box will momentarily turn yellow to indicate the
selection. Press the < to return to the previous screen.
• Inspect wire insulation inside cut armor for nicks.
The Notching Blade may contact wire insulation. To
reduce nicking, adjust notch depth to the minimum
depth necessary to break through armor.
• Use anti-short bushings where required. Cut armor
may nick wire insulation.
Failure to observe these precautions may result in
injury or property damage.
Note: For FMC cable, the cable type box must end with
"FMC". This will notch the cable at the end of the whip.
Whip Config
b. Touch the Whip Config box to enter the Whip
Length, Lead Length, Tail Length, and Whip
Quantity or select a whip configuration in
memory (Figure 12).
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
A total of 96 whip configurations can be stored
in memory. A whip configuration can also be
imported from the USB port by touching the
USB Import box (see instructions for USB
Import). The Page Down box accesses the next
eight whip configurations and the Page Up box
accesses the previous eight whip configurations.
To select one whip configuration, touch the
Single Job box and the Job # box adjacent to
the desired whip configuration and touch the
Load Jobs box. Both boxes will turn yellow and
the Load Jobs box will momentarily turn yellow
to indicate the selection (Figure 12).
To select multiple whip configurations of the
same cable type, touch the Multi Job box and
the Job # boxes adjacent to the desired whip
configurations and press the Load Jobs box.
The Multi Job and all the Job # boxes will turn
yellow and the Load Jobs box will momentarily
turn yellow to indicate the selections (Figure 13).
The Multi Job selection will produce in
numerical order by Job # after the whip quantity
is completed. The Clear Selections box clears
the selection. The Select All Jobs box will select
all (96) whip configurations that have proper data
entered in each field of the whip configuration.
Delete All Data deletes all 96 whip
14
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Figure 12
Figure 13

Publicité

Table des Matières
loading

Table des Matières