Service - Greenlee C3 Auto Whip Manuel D'instructions

Service

The service replacement parts for the C3 Auto Whip
clad cable cutter and replacement instructions are
listed below.
All other service repairs must be done by a Greenlee
Factory Service Center. Contact 1.800.435.0786 or
factoryserv@emerson.com for any questions
you may have.
Disconnect power before servicing this tool.
Accidental start-up could cause serious injury.
Replacement of power cord must be done by a
Greenlee Factory Service Center.
Service Kits
KEY Part No.
A 52082254
B 52082256
C 52082253
D 52082252
E 52082255
F 52082251
G 52082250
H 52082961
I 52084477
J 52084594
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
Description
Drivewheel
Blade, Circular (Cut off)
Screw, 3/8-16 LH x .70 Hex Cap
Washer (Cut Off)
Blade, Circular Saw (Notching)
Screw, 1/4-20 LH x 3/4 Hex Cap
Washer (Notching)
Bearing, Thrust 1.000 X .500 (Repair)
Lanyard, Cable
O-Ring, Encoder
29
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Wear protective gloves when
servicing this tool.
Failure to observe this warning could
result in serious injury.
Wear eye protection when servicing
this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Qty.
1
1
1
1
1
1
1
1
1
1