Emergency Stop Disengagement; History Screen; Blade History; Whip History - Greenlee C3 Auto Whip Manuel D'instructions

Operation (con't)
• Inspect wire insulation inside cut armor for nicks.
The Notching Blade may contact wire insulation. To
reduce nicking, adjust notch depth to the minimum
depth necessary to break through armor.
• Use anti-short bushings where required. Cut armor
may nick wire insulation.
Failure to observe these precautions may result in
injury or property damage.
Making corrections
Make corrections to the whip as needed by
touching the 3 boxes in Make Changes Needed.
Press Cable Type box to make corrections to the
notch depth. Press the Whip Config box to make
corrections to the whip length, lead length, and
tail length. Press the Mach Params box to make
corrections to the mach params. After corrections
have been made to the whip and verified by
inspection, press the green Cycle Start box (Figure
19). The HMI screen will show the Job Progress.
4. Job Progress screen (Figure 21) will show the
parameters for the cable type, whip lengths, the
Job #, Jobs Queued, Whip Qty. Left to run, and
Length Left On Spool. Press the green Cycle Start
box to begin the production. The < will return to
the previous screen. The production of whips
will continue until the quantity shown in Whip
Parameters box is zero. If Multi Job was selected,
the parameters for the next Job # will appear on the
screen. If the Inspect 1st Piece is ON, a 1st piece
sample will be made for each new job in
the multi-job.
Figure 20
To stop the production run, press the red Cycle
Stop box (Figure 20). The machine will complete the
whip and then stop. Production can also be stop
ped by pushing the emergency stop button the front
panel. Pushing the emergency stop will immediately
stop the production.
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter

Emergency Stop Disengagement

When the emergency stop is engaged DO NOT
attempt to pull the knob from the locked position.
Simply twist the stop clockwise to disengage the
lock. Pulling on the knob may cause damage to
the device.

History Screen

History displays the history on the last 16 Whip
Jobs completed and the history on Notching and
Cutting blades. To access the History screen, go to
the Main Menu on the HMI (Figure 9) and touch the
History box. The display will show Whip History,
Blade History, and < (Figure 22). Press < to return to
the previous screen.
1. Whip History will display the Job #, Cable
Manufacturer, Cable type, Cable Armor, whip
parameters, # of Whips, if 1st piece inspection was
used, the User, Date, run time, Page Down, Page
Up, and the < (Figure 23). The last 16 job numbers
will be stored in memory. Press the < to return to the
previous screen. Pressing the red Delete All Data
button will clear the last 16 whips stored in memory.
17
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Figure 21
Figure 22