Setup Screen; Machine Parameters - Greenlee C3 Auto Whip Manuel D'instructions

Operation (con't)

Setup Screen

8. Setup screen will display the Machine Parameters
box where the Notching Tension, Cut off Tension, Feed
Rate,Notch Rate, Saw Rate, Hold Down Offset, and
Saw Depth can be adjusted. To access the Setup
screen, go to the Main Menu on the HMI (Figure 9) and
touch the Setup box. The display will show Machine
Parameters and the < (see figure 26). The < will return to
the previous screen..
Figure 27
9. Touch the Feed Rate Setup box and the screen
will display Notching Tension, Cut off Tension,
Feed Rate, Notch Rate, Saw Rate, Saw Depth,
DEFAULT ALL, and the < (see figure 28). The < will
return to the previous screen.
Figure 28
Greenlee Tools, Inc.
C3 Auto Whip Clad Cable Cutter
Feed Rate Setup
1. Touch the Machine Parameters box and the screen
will display Notch Rate, Saw Rate, and Feed Rate
(Figure 27). Press > to display the next page of
machine parameters: Notching Tension, Cut off
Tension, Saw Depth, and Hold Down Offset (Figure
27A). Press < to return to the previous screens.
2. Notch rate is the rate the Notching Blade will
plunge into the armor on the MC cable. To change
The rate, adjust the slider scale - raise the slider to
Increase the rate or lower the slider to decrease
the rate. Press default to return to the factory
default Setting.
3. Saw rate is the rate the Cut Off Saw Blade will
plunge through the MC cable. To change the rate,
adjust the slider scale - raise the slider to increase
the rate or lower the slider to decrease the rate.
Press default to return to the factory default setting.
4. Feed rate is the rate the cable will feed into the
machine. To change the rate, adjust the slider Scale
- raise the slider to increase the rate or lower the
slider to decrease the rate. Press default to return
to the factory default setting.
5. Notching tension is the amount of tension the
feed roller will apply to remove slack in the armor
during notching. To change the tension, adjust the
slider scale - raise the slider to increase the tension
or lower the slider to decrease the tension. Press
default to return to the factory default setting.
19
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Figure 28A