Ugolini ICON Carnet D'instructions page 20

ICON
7. 3. 2 DISMANTLING THE COVER
1
Click open the two parts. (see figure 9).
figure 9
2
Remove the left part of the cover and then
the right part. (see figure 10).
figure 10
7. 3. 3 CLEANING
ATTENTION
Before any disassembly and/or cleaning
procedure make sure that the dispenser is
disconnected from its power source.
IMPORTANT
Do not attempt to wash any machine
components in a dishwasher.
1
Fill a basin with approximately one gallon of
hot water (45-60°C) and sodium hypochlorite
(bleach) at a ratio of 200 ppm per 2 litres of
water; indeed, a solution that is too concentrated
may damage the parts to be washed, whereas
one that is too diluted may not clean properly. Do
not use any abrasive detergents.
IMPORTANT
In order to prevent any damages to the
dispenser use only a detergent suitable
with plastic parts.
2
In order to avoid damaging the dispenser,
only use detergents that are compatible with
plastic components.
ATTENTION
When cleaning the machine, do not allow
excessive amounts of water around the
electrically operated components of the
unit. Electrical shock or damage to the
machine may result.
3
Wash the evaporator cylinder, the upper tank
and the connecting pipe using the brush supplied
with the unit.
4
Rinse all washed parts under running water.
7. 3. 4 SANITIZING
Sanitising must be done immediately before
starting up the dispenser. Do not allow it to
remain idle for a long time after sanitisation.
1
Before starting the procedures described
20