Description Of Controls - Ugolini ICON Carnet D'instructions

ICON
5
If you wish to make a beverage rather than
crushed ice, dilute the concentrate further (about
20%). If using natural products (such as lemon or
orange juice or coffee), dissolve 150-200 grams
of sugar in each litre of the product.
IMPORTANT
Operate the dispenser with food products
only.
IMPORTANT
However Granita mix may be done, its Brix
(sugar percent content) must be at least 13.
6
Press the switches

DESCRIPTION OF CONTROLS).

7
The dispenser must always be used with the
c o v e r s a s s e m b l e d , i n o r d e r t o a v o i d
contamination of the product with external
agents.
8
The dispenser must operate continuously:
the cooling system of each container will stop
automatically when the product is ready to be
dispensed maintaining the set density. The
stirring devices will continue to run.
9
If you use the dispenser with milk-based
products, never switch it off. When not in use
activate the storage function.
7. 1 DESCRIPTION OF CONTROLS
The dispenser has a master switch on the panel
on the left side. Each container also has a
thermostat for adjusting and displaying the
temperature of the product, and two keys for
activating mixing and selecting the type of cooling
of the product. It is possible to make as many cold
products as iced ones like crushed ice or sorbets.
When the beverage function is selected, the
temperature of the beverage can be adjusted at
the thermostat. When the crushed ice function is
selected, the density of the product is adjusted by
turning the adjustment screw in each of the back
walls of the dispenser (for adjusting the
temperature and density, refer to chapter 7.2
SUGGESTIONS).
ETC VERSION
The functions of the dispenser's controls are
(see chapter 7.1
16
listed below (see figure 1).
figure 1
Power switch (A)
0 position : dispenser switched off.
I position : dispenser switched on. Fan on
and mixer on.
Mixer and cooler keys (A) and (C)
Switch A : press to activate the BEVERAGE
function. The indicator light (B)
comes on when this operating
mode is activated.
Switch C : press to activate the CRUSHED
ICE function. The indicator light
( D ) c o m e s o n w h e n t h i s
operating mode is activated.
Display (E)
The temperature of the product in the container
appears on the display.
Temperature alarm: the displayed temperature is
normally steady. If it is flashing, the temperature
of the product has remained for a certain time
above the maximum conservation temperature
and it is advisable to check deterioration of the
product.
To reset the alarm and stop the temperature from
flashing, hold down key (C) for three seconds.
IMPORTANT
If the dispenser is started with the product
in the containers above the conservation
temperature, the display will flash. To reset
the alarm and stop the display from
flashing, hold down key (C) for three
seconds.
IMPORTANT
Conservation temperature is set at the
factory at 4°C.
Cleaning mode: hold down key (A) for three
seconds to activate CLEANING mode and "--.--