Publicité
Les langues disponibles
Les langues disponibles
Installation
3 - Cabling
WARNING
If there is a doubt as to your ability to install the amplifier and to cable the system properly, get a
Focal distributor to do it for you.
WARNING
Before you begin the connection phase of set-up, remove the vehicle battery's negative (-) terminal
CAUTION
Avoid routing power supply cables close to low-level input cables (RCA), to your car's radio aerial, or to
sensitive units. High-current power supply cables can cause static/interference that affects audio signals.
CAUTION
Keep cables as short as possible to optimise the system's set-up performance and to reduce
signal loss.
3.1 - What power supply wire gauge should I use?
Amplifier
Main fuse
FP Dual Monitor
*AWG : American Wire Gauge
notice dual monitor gb.indd 7
notice dual monitor gb.indd 7
0 - 4m
35mm
160A
2AWG*
Length of Cable in Metres
4 - 8m
2
53mm
0AWG
(fig. 1).
2
07
28/09/06 17:14:19
28/09/06 17:14:19
Publicité
