Focal FP Dual Monitor Mode D'emploi page 4

FOREWORD NOTES
Material required for the installation:
• 2 conduits of suitable cross-section (1 conduit for the power cable, 1 conduit for the loudspeaker, REMOTE,
RCA signal and REMOTE CONTROL cables).
• Multimeter (voltage/amperage)
• Soldering iron + solder
• Crimping tool
• Stripping pliers
• Wire cutter
• Spanner for battery terminal
• Hand drill and assorted drills
• Heat shrinks of suitable diameter for the different cables.
• Power cable of suitable length and section
• Remote turn on cable (REMOTE) of suitable length and section
• Ground cable of suitable length and section
• Assorted connectors
• Fuse holder and suitable fuse
• Joint tag for the battery's positive (+) terminal
• Joint tag for the vehicle's chassis (-)
• Screw with minimum 6mm screw head and its nut for ground connection to the chassis of the vehicle.
04
notice dual monitor gb.indd 4 notice dual monitor gb.indd 4 28/09/06 17:14:17 28/09/06 17:14:17