Technical Specifications - Focal FP Dual Monitor Mode D'emploi

Technical specifications

Nominal power measured at 13.8V
continuously @ 4Ω
Nominal power measured at 13.8V
continuously @ 2Ω
Power in bridge mode measured at
13.8V continuously @ 4Ω
Power in bridge mode measured at
13.8V continuously @ 2Ω
Power supplies
Signal/noise ratio
Damping factor at 4Ω
Frequency response
Input impedance
Input sensibility
Digital input
Output stages
Operational amplifiers
DSP
Converters
Software
Remote control
Digital EQ (each input channel)
Digital delay line (each input channel)
Digital control
High-pass filter (with on/bypass switch)
Low-pass filter (with on/bypass switch)
Parametric EQ (Q Bass)
Maximum cross section of loudspeaker
cables
Maximum cross section of power cables
Protections
Dimensions (H x W x D)
Weight
Comment: In our endeavour to continually improve our products, Focal reserves the right to modify the technical specifications of this product without prior notice.
notice dual monitor gb.indd 13 notice dual monitor gb.indd 13
FP Dual Monitor
2 x 250WRMS
2 x 400WRMS
1 x 800WRMS
1 x 1200WRMS
Dual fully regulated
> 110dB (A)
> 600
10Hz – 40kHz
13kΩ
0.2 – 5V
Coaxial/optic
Transistors :
6 x Toshiba 2SC5200
6 x Toshiba 2SA1943
Burr-Brown®
2 internal DSP , 180 MIPS per DSP
24-bit/96kHz Crystal®
Provided
Provided (gain + 5 presets)
30 bands of 1/3 octave
4 independent outputs, 22ms max
From external PC via USB port
Frequency and slope fully adjustable
Frequency and slope fully adjustable
1 band fully adjustable
10mm 2
7AWG
53mm 2
0AWG
Short-circuit
Continual power
Over-heating
Clipping limiter
Overvoltage
Polarity reversal
50 x 540 x 280mm (2 x 21.25 x 11")
7.5kg (16.53lb)
13
28/09/06 17:14:21 28/09/06 17:14:21