Table des Matières
Publicité
PPH50B - NLFREN - v1.0.1 - 21042017
EN
•
Attach visible signs on the equipment so that anyone recognizes and understands that maintenance or inspection is on
going.
•
Post a list with emergency phone numbers nearby the working area.
•
Before maintenance pressured parts in the machine, you MUST release the pressure in the pressured system. At the same
time, DO NOT stand in the direction facing the charger, the operator should on the opposite side and remember DO NOT
strike, press or transfer until it is discharged.
•
When it is necessary to exchange die after running, operators should wear glove or use tools to operate avoid being hurt.
CAUTION!
Immediately stop operating the equipment if not working properly. Contact a certified technical
support engineers for repair. The equipment must not be operated without approval from the
certified technical support engineer.
WARNING!
The warnings, cautions and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be
supplied by the operator.
2 Technical specifications
2.1 Application area
The machinery described is intended for machinery production and assembling spare parts. It is used to press, size, assemble,
rivet small parts in process and not for other use.
2.2 Technical data
Model
Capacity
Stroke
Pressure of hydraulic system
Working range
Air inlet
Air pressure
Bed width
Speed
Height above floor
Covered area/width
Covered area/length
Net weight
Working temperature
Storage temperature
Shipping temperature
Altitude
Humidity
Atmosphere
Ambient light
Noise level
PPH50B
50 ton
200 mm
62.42 MPa
62 ~ 1042 mm
1/4''
0.75 - 0.85 MPa
259 mm
1,2 mm/s
1920 mm
1090 mm
1360 mm
282 kg
-5 - +40 °C
-25 - +55 °C
-25 - +70 °C
The machine should be installed at an altitude of maximum 1,000 m
Maximum 85% relative humidity at 40°C without condensation
Non-flammable, noncorrosive and dust free
> 300 Lux
< 85 dB(C)
13
TOOLS
Publicité
Table des Matières
