Generate Test Code; Print Last Test Results - Midtronics inCHARGE 940 INC-940 Manuel D'instructions

GENERATE TEST CODE

You can generate a test code* at the end of a completed (non-aborted) automatic charging session.
IMPORTANT: You will not be able to select GENERATE TEST CODE if you abort the charge,
disconnect the clamps, or turn off the inCHARGE940 before generating a test code. A test
code is unavailable if you charge the battery using Manual mode.
1. Select GENERATE TEST CODE.
2. REPAIR ORDER#: Enter the 5-digit repair order number.
3. LAST 4 OF VIN: Enter the last 4 digits of the vehicle identification number (VIN) and press
ENTER. The inCHARGE940 will generate a 14-character alphanumeric test code and display it
on the screen.
4. Place the IR printer in the cart's printer bracket and turn on the printer.
5. Press ENTER to print the test results.
NOTE: The inCHARGE940 will not generate a test code unless you enter a Repair Order Number and
the last four digits of the VIN.
*IMPORTANT: The test code is required on every warranty claim.

PRINT LAST TEST RESULTS

1. Place the IR printer in the cart's printer bracket and turn on the
printer.
2. Select PRINT LAST TEST RESULTS and press ENTER.
3. PRINTING RESULTS will appear on the display as the results
of the last test are printed.
NOTE: To abort printing, press STOP.
If you turn off the inCHARGE940 or disconnect the clamps, the
inCHARGE940 will save the last test results in memory for printing until
you start a new battery analysis/charging session. To print, press the
INFO ( i ) button when the message CHOOSE CHARGE MODE
appears. Use the ARROW buttons to scroll to PRINT LAST TEST
RESULTS, and press ENTER.
- 13 -
inCHARGE 940 Ver 1.0
(c) 2002 MIDTRONICS, INC
10/17/02
15:01
DEALER NUMBER
A1B2C3
REPAIR ORDER #
12345
LAST 4 OF VIN
1234
BATTERY TEST
WARRANTY
RATING:
280 A DIN
12.85 V 308 CCA
GOOD BATTERY
CHARGE TIME:
48 MIN
TEST CODE
2FKT458-G3G5H7K