Safety Instructions - Midtronics inCHARGE 940 INC-940 Manuel D'instructions

La station de chargement diagnostique par conductance pour l'analyse et la charge des batteries automobiles de 12 volts

Masquer les pouces

Table des Matières

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS: READ AND SAVE

THIS SAFETY AND INSTRUCTION MANUAL. KEEP IT WITH

OR NEAR CHARGER AT ALL TIMES.

WARNING: RISK OF EXPLOSIVE GASES

1.1

WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES

GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION, AND WHEN

DISCHARGED OR CHARGED. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE

THAT EACH TIME BEFORE USING YOUR CHARGER, YOU RE-READ THIS MANUAL AND

MAKE CERTAIN YOU FULLY UNDERSTAND IT AND FOLLOW THE SAFETY AND

OPERATING INSTRUCTIONS EXACTLY.

1.2

To reduce risk of battery explosion, follow these safety instructions and those published by

the battery manufacturer and the manufacturer of any equipment you intend to use in the

vicinity of a battery. Review cautionary marking on these products and on engine, and on

vehicle or equipment containing the battery.

1.3

CAUTION: To reduce the risk of injury, charge only rechargeable LEAD-ACID TYPE

batteries which may include MAINTENANCE-FREE, LOW-MAINTENANCE OR DEEP

CYCLE batteries. Other types of batteries may burst causing personal injury and damage.

If you are uncertain as to the type of battery you are attempting to charge, or the correct

procedure for checking the battery's state of charge, contact the seller or battery

manufacturer.

1.4

Use of an attachment not recommended or sold by the battery charger manufacturer may

result in a risk of fire, electric shock, or injury to persons.

1.5

To reduce risk of damage to electric plug and cord, pull by plug rather than cord when

disconnecting charger.

1.6

Position AC and DC leads to avoid tripping over them and to prevent damage by hood,

doors, or moving engine parts; protect from heat, oil, and sharp edges.

1.7

Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged

in any way; take it to a qualified service center.

1.8

Do not disassemble charger; take it to a qualified service center when repair is required.

Incorrect reassembly may result in a risk of electric shock or fire.

1.9

If the charger is in need of service, call Midtronics at 1-800-776-1995 or 1-630-323-2800.

1.10

To reduce risk of electric shock, unplug charger from the AC outlet before attempting any

maintenance or cleaning. Turning off the controls will not reduce this risk.

1.11

Do not overcharge battery. See Safety Instructions (3).

1.12

When charging a battery, locate in a dry, well-ventilated area.

1.13

Never place articles on or around charger, or locate charger in a way that will restrict the flow

of cooling air through cabinet.