7 CARE AND MAINTENANCE
7.1
Maintenance information
The XT and P ranges assembling components are the following:
ETR8-2, ETR12-2, ETR15, and ETR15P mounting accessories.
XTLIFTBAR rigging accessory.
If these components are used as it is described in this manual, they will remain fully operational over the enclosures' life.
However, it is necessary to regularly check the following points in order to guaranty the system durability:
!
The ETR8-2, ETR12-2, ETR15, ETR15P, and XTLIFTBAR as well as the shackles and pins should not
show any deformation, fissure, or corrosion.
Any component incorporating a part showing signs of defect must immediately be replaced.
WARNING
!
The sockets on any enclosure should not show any signs of deformation, fissure, or corrosion. They
must be securely fixed to the enclosure.
Any enclosure incorporating a part showing signs of defect must immediately be put aside and
withdrawn from use to be inspected by qualified service personnel.
WARNING
!
Ensure that each ball locking pin and spring-loaded safety on the ETR12-2, ETR15, ETR15P, and
XTLIFTBAR operates correctly by moving its mechanism and checking that it automatically returns
to nominal position.
Ensure that the safety pin on the ETR8-2 locks correctly.
WARNING
7.2
Spare parts
The spare parts available for the customer are listed in the table below. Any other part must be replaced by qualified
service personnel for safety purposes.
XT-P_RM_ML_2.0
Table 1: Available spare parts for the customer
ETR8-2
ELINGUE60
CA BOUT10
ETR12-2
CA ETRPIN
ETR15
CA ETRPIN
ETR15P
CA BOUT10
XTLIFTBAR
CA ETRPIN
CA MAN8
w w w . l - a c o u s t i c s . c o m
Safety pin
Knob
Ball locking pin
Ball locking pin
Knob
Ball locking pin
Shackle
EN
25 en