Disassembling Procedure - L-Acoustics Coaxiale XT Serie Mode D'emploi

3. Select the site angle by positioning the shackle into a hole from 1 to 5, corresponding respectively to the site
angles +14°, +7°, 0°, -7°, and -14°.
!
If the azimuth angle setting is not 0°, ensure that the shackle is positioned into the hole 3 in
order to properly balance the center of gravity.
CAUTION
4. Attach the motor hook to the shackle and raise the enclosure to desired trim height.
L-ACOUSTICS
!
To attach it, a safety eyebolt accessory can be added using the M8* insert located on the rear
face of the 12XT or 115XT HiQ enclosure (see Figure 23).
WARNING
* The "M8" notation refers to the European standard (see applicable external documentation).
6.5.2

Disassembling procedure

The disassembling procedure is the exact reversed sequence of the assembling procedure.
XT-P_RM_ML_2.0
4
3
2
1
Figure 22: -7° site angle setting (hole 4)
® recommends using a safety sling when flying an enclosure.
w w w . l - a c o u s t i c s . c o m
5
EN
23 en