Description Of Terminals; Wiring Instructions For The Use Of The Device Without The Rj45 Adapter - Urmet alpha iPercom 1060/48 Notice D'installation Et Utilisateur

4. DESCRIPTION OF TERMINALS

]
PA Hall button
]
SE2 Garage relay contacts
SE - Pedestrian electrical lock with capacitance discharge actuation negative
SE +
Pedestrian electrical lock with capacitance discharge actuation positive
5. WIRING INSTRUCTIONS FOR THE USE OF THE DEVICE
WITHOUT THE RJ45 ADAPTER
• Remove the RJ45 adapter (19) from the POE connector (18).
• Remove the insulation sheath of the CAT5/CAT5E cable (with rigid wires) for at least 40 mm.
• Strip the conductors for no more than 6mm.
• Insert the wires in the connector (18) respecting the positions and colour codes shown (Standard
T568B).
Pressing the orange clips on the terminal block with a screwdriver makes it easier to insert the
conductors into the terminal block.
1
Wire No. Wire colour
1 White-Orange
2 Orange
3 White-Green
4
Wires with cross-section area of 0.5 mm
cross section area smaller than 0.5 mm
Refer to the instructions contained in the system manual for maximum distances and confi guration
operations.
To insert the USB cable, if using a display module and ILA cable, if using an ILA and voice synthesis module,
follow the instructions below.
10
8
Wire No.
5
6
7
Blue 8
1
Wire colour
White-Blue
Green
White-Brown
Brown
or larger must comply with IEC 60332-1-2; wires with
2
must comply with IEC 60332-2-2.
2
2
USB ILA
DS1060-148