Simplified Eu Declaration Of Conformity - Urmet Cloud Camera Serie Guide Rapide

EN
1 Warnings
Video recording
This device is not designed as a burglar system but mainly to transmit and record video images. URMET
S.p.A. is not in any way responsible for loss or damages of the user consequent to theft.
Before using the device, record a demo video to verify the correct functionality of this feature. URMET
S.p.A. is not in any way responsible for loss of recorded data consequent to wrong setting or usage,
device misfunctioning or failure.
This device is composed by electronic precision components. Do not hit the device while recording as
it might affect the video.
Privacy and Copyright
The IP camera is designed for surveillance systems. Video recording is subject to the laws applicable
to the Country where used. It is forbidden to record images with Copyright.
The User is responsible to check and respect all local laws and norms for video signal recording. The
manufacturer is NOT in any way liable for any usage of the product which might result not compliant
to the relevant norms.
Firmware upgrade
Refer to URMET S.p.A. Customer Service Technical Assistance periodically to check availability of
firmware upgrades.
Network configuration
Default IP address of the IP camera in AP (Access Point) mode (factory default mode): 223.223.100.1.
When connecting to a router, the camera is set to DHCP mode. To connect to the camera also from a
PC workstation, use the "EasyTool" software (see following sections).
Network connections
When connecting a PC (using Software Client or Browser), any video channel on the PC will be using
"unicast" connection (TCP, RTP, UDP).
The device can support a limited number of "unicast" connections so it is possible to show the video
on maximum 4 remote devices (of which 2 smartphones at the most) at the same time depending on
the available network band.
Reset button
Press for at least 3 seconds: the camera is completely reset and goes back to default settings.

2 Simplified EU declaration of conformity

Hereby, URMET S.p.A. declares that the radio equipment type: camera 1099/211 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following
internet address:
3 Installation
It is advisable to proceed as follows for correct camera installation and configuration:
1 Make sure that no units are powered before starting the installation procedure. It is advisable
to install and configure one camera at a time if you are installing multiple cameras on the same
network.
2 Connect the camera to the network (see section 4). It is advisable to check that the Wi-Fi signal
received by the camera is higher than or equal to 60.
3 Position the camera in a point on the wall or other surface and adjust the bracket to frame the
DS1099-061A
www.urmet.com
8