PNI Escort Start 360 Manuel D'utilisation page 36

will chirp 3 times.
Notes: Please be noted that there should not be strong radio frequency around and the
distance between the Communication Module and the Remote Control shall be over
2.5m during the learning process or the learning will be affected or fail.
34. Tips for trouble shooting
1. After installation of the main control module, the siren sounds continuously and
cannot be stopped by remote control.
- Check whether the plug is inserted in opposite side.
- Check whether the wire connections are correct.
- Check whether the fuse is burnt.
- Check whether the main control module is match with the remote codes.
- If back-up siren is used ,please check the switch of it.
2. While the armed vehicle is parked on the roadside, the alarm will sound every time
when a big or heavy vehicle is passing.
- Check whether the sensitivity is too high.
- Reduce the sensitivity.
3. When the alarm system is triggered, the siren will not sound.
- Check whether there is a problem with the siren.
- Check the connection between the siren and the main control module.
4. When using 2-way remote control, the range is short or the range is getting shorter.
- Check whether the communication module is mounted in the proper location. (The
optimal location is the backside of the rear-view mirror.)
- Check whether the battery of the Remote Control is low.
- Check whether the plug of the communication module is correctly connected with the
socket on the main control module. The tall buildings or high frequency radio around will
also affect the range.
- Check whether the Remote Control is broken.
* To find out whether the Remote Control used has the above problems, you may
compare it with the other one.
5. 10 seconds after arming the alarm, the siren will sound indefinitely. Disarm the alarm
then arm it again, the same case will happen again.
- Check whether there is problem with the shock sensor.
- Check whether the sensitivity of the shock sensor is too high.
- Check whether the door trigger and brake1.
- Check whether the wire connections are correct.
6. The engine fails to start only
- Check whether the wire connections are correct
- Check whether the power is getting weak
- Check whether the key is with chip, need to install immobilizer
bypass module.
- Check whether the purple wire connection is correct
35 35
EN