Short Description - PNI Escort Start 360 Manuel D'utilisation

SHORT DESCRIPTION

1. Main control unit - It is a main part of the vehicle security system and it is usually
installed in a hidden location under the bottom of the dashboard in the vehicle. Use the
wiring diagram as a reference, connect the module wires to the vehicle's ignition,
parking lights, constant power, etc respectively. Make sure to connect each wire firmly
and protect the connected part of the wire properly with quality electrical tape to make it
perfectly insulated. After the connection of each wire, insert the plugs into the module
connectors. Test the system with the remote control to see whether each button
functions correctly. If all is ok, then bundle the wires orderly and put the existing vehicle
wiring harnesses back the original locations.
2. Communication module - It transmits and receives RF signal with the remote control.
It is a key component of the system so the selection of the mounting location is very
important. Normally it is mounted on the back of the rear-view mirror. It shall not be close
to the silver-gilt film on the windshield or the transmission and receiving of the module
will be affected. The distance between the module and the metal frame of the vehicle's
body shall not be less than 5 cm.
3. Shock Sensor - It is an intelligent dual stage shock sensor that can distinguish
whether the vehicle is impacted lightly or heavily. When an impact is applied to the body
of the vehicle, it sends signal to the Main Control Module to set off siren alarm sound
and to make Remote Control emit audio and visual warning signals. The Shock Sensor
should be firmly mounted on the frame of the vehicle's body so that it can respond to the
external impact as correctly as possible. After installation, adjust the sensitivity to the
desired level according to the actual need and the size of the vehicle. (The sensitivity
has been set to an optimum level in the factory. Please do not adjust it again if it is not
necessary.)
4. Siren - If installed, alarm sound of higher than 110 dB is set off from the siren when the
vehicle is attacked. It should be mounted in a place to protect it from heat and water
damage.
5. Remote control - The Remote Control mainly consists of FSK electronic circuits, LCD
screen, melody buzzer and a vibrator. Each graphic icon displayed on the LCD screen
and each different melody/beep sound tone emitted from the Remote Control gives you
both visual & audio information on the vehicle's status, every operation status/process
of the System or System's present status. The Remote Control is a kind of precision
product, please do not drop it on the floor or dip it into water. Operation near high radio
frequency or kept in an environment with a temperature higher than 60°C is prohibited.
The remote control range will be affected if the security system is installed in the vehicle
with solar film.
POINTS TO BE NOTED FOR YOUR BETTER USE
As the system is of two-way signal transmission, sometimes the time required
for communication takes longer than usual when communicating remotely either to
operate the system or to check the operation result since a large amount of information
is to be exchanged between the TX part and RX part of the system with one press of
21 21 21
EN