PNI Escort Start 360 Manuel D'utilisation page 30

NOTES: For some cars there are no pin switches for the rear passenger doors.
If the alarm system is installed in this kind of cars, when only open the rear passenger
doors after disarming the alarm, the system can not detect that the rear doors have
been opened and the parking lights will not flash. 25 seconds after disarming the alarm
it will automatically re-arm and lock the doors. If only the rear doors are opened and they
are closed after 25 seconds, the system will be triggered by shock sensing.
18. Closing Door Reminder
In the event that you arm the alarm with remote control while any of the doors is
not closed completely, then after 15 seconds, the siren will sound and the parking lights
will flash for 25 seconds, the engine will be disabled. The Remote Control will beep for
15 seconds and vibrate 4 times to remind the user, the door icon and parking light icon
will flash for 15 seconds.
19. In-Range Indicator
While the alarm is armed, if the remote control cannot receive the signal from
the Main Control Module for 2 or 3 minutes, the signal intensity indicator
screen will disappear to indicate that the remote control is out of range.
20. Remote Engine Start (For automatic transmission car)
A. While the alarm is armed, press
within 3 seconds, the siren will chirp once, the turn signal lights
will flash once, the Remote Control will beep 3 times and the
engine will start. After the engine is started the Remote Control
will beep 3 times again, the turn signal lights will flash once every
two seconds. The LCD screen on the Remote Control displays
as picture.
B. Once the vehicle has started, it will run for the preprogrammed period of time
(either 8, 16, 24 or 60 minutes) then shut down and the system will enter armed state
again. While the remote started engine is running, you may press
it down, the Remote Control will beep 3 times and the system will enter armed state
again.
C. If the hand brake is disengaged while trying to start the engine with Remote
Control, the siren will emit 3 short chirps and the engine will not start.
D. If you want to drive the vehicle while the remote started engine is running,
press button to disarm the alarm and unlock the doors, turn the ignition key to ON
position within 30 seconds or the engine will shut down.
NOTE:
1. If you start your car with the remote, the vehicle will try to start the engine 3 times. If it
fails to start please check the wire connection of the remote engine start circuit.
2. After the engine is started successfully then it cranks again, please check whether the
purple detecting wire from the main control module is correctly connected to the correct
alternator wire or the engine oil pressure indicator wire. (These two wires are with
button twice
29 29
EN
on the LCD
button to shut