PNI Escort Start 360 Manuel D'utilisation page 29

Masquer les pouces Voir aussi pour Escort Start 360:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 61
memorized When using the remote control to disarm the system, the siren will
emit 4 short chirps to remind the user that the vehicle has been triggered and the user
needs to check the vehicle.
13. Emergency Override
The emergency override function may be used if the remote control is lost or
inoperative. Open the door with the key (the siren will sound), turn the ignition key to ON
position within 10 seconds, then press the Override switch twice, the alarm will stop
sounding and enter the disarm mode. You can now start and operate the vehicle
normally. But please be noted that the alarm system will not provide security service
with your vehicle before the system is resumed to use.
Important: The emergency override switch should be installed in a hidden location
where it is convenient to operate.
14. Stop alarm sounding temporarily
While the alarm is sounding after it has been triggered, you may press
or
to stop sounding and the system will resume to the armed state again. (If the
trigger is not removed, the alarm sounding will only pause for 3 seconds then continue
till the trigger is removed or the alarm is disarmed.)
15. Turning off the parking lights reminder (Optional )
Lock the door after getting off, but forget to turn off the light, and try to arm , then
the siren will chip 7 times fast, the light will flash 3 times, and the remote will sound "Bi"
once and the light icon will flash once, the state of the remote is same as that the alarm is
armed.
16. Timer and alarm clock setting
Press and hold
displayed on the LCD screen. Press to select your desired setting among Alarm Clock
(A.C.), Clock (CLK.) and Exit (EX.). The selected characters will flash quickly for setting,
at this moment you may press
finishing the first digital adjusting, press to set the next digit. Press and hold
seconds again to save the setting and exit the programming mode. If no button is
pressed within 10 seconds, the system will also save the current setting and exit the
programming mode, the remote control will beep once and "EX." will illuminate once to
confirm.
17. Automatic Rearm
Press
within 25 seconds the system will automatically re-arm itself and lock the doors, the
remote control will beep once to confirm. (The icons on the LCD screen will be same as
arming the alarm).
&
for 2 seconds, with a melody sound and the "SET" will be
to disarm the alarm while it is armed. If none of the doors is opened
to adjust the parameter of the flashing digit. When
28
28
EN
button
&
for 2

Publicité

Table des Matières
loading

Table des Matières