Remote Control Description - PNI Escort Start 360 Manuel D'utilisation

button. The unique transmission logic that has both wake-up mode and sleep
mode during communication may also result in such delay of signal transmission. For
instance, if a signal from TX part is sent to RX part of the Main Control Module while it is
in sleep mode, the RX part may not recognize the signal sent by TX part for a few
seconds until when the RX part of the Main Control Module gets in wake-up mode and
visa versa. Due to the same reason, when you shut down any of the system's operation
and if there are no response with your first press of a button, we recommend you to
press the button again after waiting 3 seconds.
ATTENTION: We recommend installing the system at an authorized service.

REMOTE CONTROL DESCRIPTION

Battery
charger
input
Arm
button
1. button
- after pressing this button the car doors will lock and the security system will confirm the
arming by sound and light
- press this button when the system is armed to locate your vehicle, both by sound and
lights
- press this button while driving to lock all car doors
- press this button during alarm to stop sound
2. button
- pressing this button will disarm the system and unlock all the car doors
- press this button for 2 sec to activate the remote control if you deactivated it previously
- press this button for 4 sec to deactivate the remote control
- press this button while driving to unlock all car doors
3. button
- pressing this button the car doors will lock and the security system will arm in silent
mode
- when the system is armed press this button to locate the vehicle
- during alarm press this button to stop siren
- while driving press this button 2 times to enter anti-hijack mode
- While the system is armed, press
bypassed temporarily.
Antenna
LCD display
Disarm
button
and at the same time, the shock sensor will be
22
Silent mode button
enable/disable
Search vehicle button
Start engine/open trunck
button
EN