Lindy 39416 Guide D'installation Rapide page 5

QIG
Installation
Front
1. Video LED – Lights up when remote IP session is active
2. Power LED – Indicates Power
3. 2 x USB Device Ports – USB HID ports to plug in keyboard and mouse
4. Debug port – For service use
5. DVI-I Out – Connect to a DVI-D or VGA display
6. 2 x Ethernet Hub – Connect to a network
Rear
1. DC 5V – Connect the 5VDC 3A PSU
2. DVI-I In – Connect to a DVI or VGA PC, Server or KVM device
3. USB In – Connect to a USB port of PC, Server or KVM device
4. Power Control – For future use
5. PS/2 In – Connect to PS/2 port of PC, Server or KVM device
6. USB WiFi – Connect to a WiFi USB dongle with Realtek RTL8192CU chipset (optional)
Important! Before starting the installation, please ensure that all devices are powered off.
The following steps are for a basic installation using DVI equipment in a standard KVM installation, if you
are using VGA equipment, please substitute the DVI-A to VGA adapter (included) and a VGA cable (not
included) with DVI cables where required.
1. Connect your DVI equipped PC to a DVI-I In port using a DVI cable.
2. Connect your PC to the USB In port using a USB Type A/B cable or to the PS/2 In port using the
PS/2 to dual PS/2 cable.
3. Connect a DVI display to the DVI-I Out port using a DVI cable and USB keyboard & mouse to the
USB device ports.
4. Connect one Ethernet port to a network using a Cat.5e cable.
5. Plug the DC power supply into the DC 5V power socket and switch on.
6. Power on your Computer and display to complete the installation.
English