Battery Screen Functions Descriptions; Charging The Battery; Operation - Active TIGERCUT 40 Manuel D'utilisation Et D'entretien

Battery screen functions description
Single cells voltage

Charging the battery

It is recommended to charge new battery before the rst use of the electric pruner.
To charge the battery, ensure the battery power switch is in OFF position. Plug the
battery charger output into the battery charging jack, plug the charger into a power
socket and the switch to ON position. The LED indicator on the battery will turn RED
during charging and turn GREEN when the battery is fully charged. The battery takes
about 2 hours to obtain full charge. A fully charged battery can sustain 6-8 hours of
continuous pruning operation.

Operation

1. Connect the Pruner to the power cord (as shown in Figure 1).
2. Connect the power cord to the battery (as shown in Figure 2).
3. Put the battery on your waist.
4. Turn on the power switch.
5. Pull the trigger two times continuously and quickly to start the Pruner,
so that you can start working normally with the Pruner.
6. If the branches are small in diameter and you want to speed up the cut, set the
blades opening at 30 mm instead of 40 mm. To do this proceed as follows: keep the
trigger pressed for 2 seconds, until you hear an acoustic signal. To restore the previous
setting, repeat the procedure.
CAUTION
To set the system language, press the M key, scroll with the arrows to
select the desired language and con rm by pressing the M key again.
The battery display will automatically turn o after about 5 minutes to save
power. For reasons related to operator safety, if the trigger is not pressed,
after 3 minutes the scissor goes into STANDBY mode. To reactivate it, press the trigger
twice in quick succession. A single press does not reactivate the scissors to avoid
accidental closing of the blades.
Cutting times
at present
Maintenance cycle
1000 times
Total cuts
300000 times
30000 times
Figure 1
Recharge cycles
115
Figure 2
20
Battery capacity
at present
%
75
Figure 3