Software Version; System Reset - Sangean DPR-99 Plus Mode D'emploi

Software version

The software display cannot be altered and is just for your reference.
1. To view the software version on the display press and hold in the
Info/Menu button for two seconds.
2. Press the Tuning Up/Down buttons until the display shows
"Sw version" on the lower line. The version number is then shown on
the upper line of the display. After a few seconds the display will
revert to normal tuning mode.

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and hold down the Info/Menu button for 2 seconds.
2. Press the Tuning Up or Down buttons until the display shows
"Factory reset" on the lower line then press and release the
Select button to select System reset.
3. Press the Select button once more and a full reset will be performed.
All presets and station lists will be erased.
4. After a system reset a scan of the DAB band will be performed.
In case of malfunction due to electrostatic discharge, reset the
product (reconnection of power source may be required) to resume
normal operation.
GB
20