Manual Tuning - Dab; Autoselect - Dab - Sangean DPR-99 Plus Mode D'emploi

Manual Tuning - DAB

Manual tuning allows you to tune directly to the various DAB Band III
channels.
1. Press and hold the Select button until the display shows
"Manual tune". Release the Select button.
2. Press either of the Tuning Up or Down buttons to select the required
DAB channel.
3. Press and release the Select button to select the required
DAB channel. The open bar in the middle shows you the minimum
signal strength needed for good DAB reception. The signal strength
bars will go up and down showing the changing signal strength as
you adjust the telescopic aerial on your radio.
4. When a DAB signal is found, the display will show the name of the
DAB multiplex. Any new radio stations found will be added to the list
stored in the radio.
5. Press and release the Select button to return to normal tuning.

Autoselect - DAB

As an alternative to pressing the Select button to select a station your
radio can be set so as to automatically select a station.
1. Press and release either of the Tuning Up or Down buttons a
few times, immediately press and hold down the Select button until
the display shows "Autoselect ON".
2. Press the Tuning Up or Down buttons until the station you require is
visible on the display. After a few seconds your radio will
automatically select the station shown on the display.
3. To switch off autoselect press and release the Tuning Up or Down
buttons a few times, immediately press and hold down the Select
button until the display shows "Autoselect Off".
GB
10