Finding New Stations - Dab; Signal Strength Display - Dab - Sangean DPR-99 Plus Mode D'emploi

Finding new stations - DAB

As time passes new stations may become available. To find new
stations proceed as follows:-
1. Press and release the Auto Tune button, the display will show
"Fast scanning". Your radio will perform a scan of the DAB III
frequencies. As new stations are found the station counter on the
right-hand side of the display will increase and stations will be added
to the list.
2. To carry out a full scan of the entire DAB Band III frequencies press
and hold down the Auto Tune button for more than 2 seconds and
then release. The display will show "Full scanning". As new stations
are found the station counter on the right-hand side of the display will
increase and stations will be added to the list.

Signal strength display - DAB

1. Repeatedly press and release the Info button until the display shows
the signal strength.
2. Position your radio and carefully angle the telescopic aerial for best
reception using the signal strength display as a guide. Move your
radio around and position it so as to give maximum number of black
rectangles on the signal strength display. The clear unfilled rectangle
indicates the minimum signal level required for satisfactory reception.
3. Press the Info button to exit the signal strength display.
9