Manual tuning-DAB
Manual tuning allows you to tune your radio to a particular DAB frequency in Band III.
Any new stations found will be added to the station list. This function can also be used
to assist the positioning of the antenna or the radio to optimize reception for a specific
channel or frequency.
1. Press and hold the Menu button until the Advanced DAB menu shows on the display.
2. Press the Tuning up/down button until the display shows 'Manual tune'. Then press
the Select button to enter the manual tuning mode.
3. Press the Tuning up/down button to select the desired DAB channel. Then press the
Select button to confirm the selection. The open block in the signal strength graph
shows the minimum signal strength needed for good DAB reception. The signal
blocks will go up and down showing the changing signal strength as you adjust
the antenna or the radio position. Any new radio stations found on the tuned DAB
multiplex will be added to the list stored in the radio.
Dynamic Range Control (DRC)-DAB
The DRC facility can make quieter sounds easier to hear when your radio is used in a
noisy environment.
There are three levels of compression:
DRC Off No compression applied.
DRC High Maximum compression applied.
DRC Low Medium compression applied.
1. Press the Power button to switch on your radio.
2. Press the Source button until the DAB band is selected.
3. Press and hold the Menu button until the Advanced DAB menu shows on the display.
4. Repeatedly press the Tuning up/down button until 'DRC ' appears on the display.
Press and release the Select button to enter the setting. The display will show the
current DRC value which will be marked with an asterisk.
5. Press the Tuning up/down button to select the required DRC setting.
6. Press the Select button to confirm the setting. After several seconds the display will
return to the normal radio display.
Note:
Not all DAB broadcasts are able to use the DRC function. If the broadcast does not
support DRC, then the DRC setting in the radio will have no effect.
GB
7