Bartscher GE 18 Mode D'emploi page 28

•
The temperature dial can be used to set the
temperature within a range of 30 ° C - 90 ° C – MAX .
Set the desired temperature by turning the
temperature dial clockwise. The red heating
control light will come on. After the desired
temperature between 30 ° C - 90 ° C is reached
the device's thermostat will be turned off
automatically by the thermostat.
If the liquid's temperature falls the thermostat will
again resume heating, maintaining the liquid at
the desired temperature for long periods of time.
•
If the desired temperature is 100 ° C , turn the temperature dial clockwise to the
"MAX" position. The water will remain at boiling, and the thermostat will not turn
the device off automatically.
NOTE!
Heating time depends on the amount and type of liquid.
WARNING! Hot surface!
When in use the device's surface gets very hot. To avoid burns to fingers and
hands, do not touch hot surfaces! Only hold the device by its handles and only
transport it after cooling.
Pouring liquid
•
To pour liquid, place an appropriate container
(glass, cup, mug) under the spout.
•
Press the spout lever down and hold it until the
desired amount of water is poured.
•
When finished pouring, release the spout
lever and the spout will close automatically.
•
After you have finished using the device, turn the temperature dial to the "OFF"
position, remove its plug from the socket, wait for the device to dry then pour out
the remaining liquid.
Temperature dial
Heating control light
- 27 -