Installation; Terminal Arrangement; Mechanical Dimensions - LOVATO ELECTRIC DMG700 Manuel D'application

Multimetre numerique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION

– DMG700 is designed for flush-mount installation according to IEC 61554.
– Insert the device through the panel cutout, making sure that the gasket is properly positioned between the panel and the device front frame.
– From inside the panel, for each of the four fixing clips, position the clip in one of the two grooves then press on the clip end until it snaps into the second groove.
– Push the clip forward pressing on its side and making it slide in the grooves until it presses completely against the internal surface of the panel.
G
B
TOCK
– Repeat the same operation for the four clips.
– In case it is necessary to dismount the multimeter, lift the middle lever of the clip in order to release it, then pull it backwards until it slips off.
– For the electrical connection, see the wiring diagrams in the dedicated chapter and the requirements given in the technical characteristics table.
– Once the wiring is completed, it is possible to mount the terminal covers supplied with the device. These terminal covers are sealable, making device tampering and/or access to the screw terminals impossible.
– To install the terminal covers, insert the side hooks in place and apply slight pressure until they snap in place. Make sure to match the terminal block with the proper terminal cover.
– The sealing of the terminal covers must be done inserting the proper wire in the side eyelets and applying the seal.

TERMINAL ARRANGEMENT

MECHANICAL DIMENSIONS

92
96
53.2
19
61.5
17

Publicité

Table des Matières
loading

Table des Matières