Troubleshooting; Cleaning, Maintenance And Repair; Disposal; Accessories - Baumer CombiTemp TFRH Manuel De Mise En Service

CombiTemp™ TFRH/N
Configuring with USB cable and PC
Remove front cover/DFON display from TFRH/N.
f „
Connect PC directly to FlexTop 22x2 with a
f „
Micro-B USB cable and set parameters.
Configuration in explosive atmospheres
9 Power supply off
Disconnect TFRH/N from circuit.
f
„
Remove TFRH/N and take it to a safe area
f
„
(outside of the explosive atmosphere).
Start configuration.
f
„

Troubleshooting

9.
Fault
Display is off and no
signal from transmitter
Display is on but no signal
from transmitter
Display is off but there is a
signal from transmitter
Display does not show the
correct data

10. Cleaning, maintenance and repair

Cleaning
Clean, disinfect or sterilize sensor as needed
f „
(CIP/SIP).
Maintenance
Regular maintenance is not required.

11. Disposal

Do not dispose of in household
f
„
waste.
Separate materials and dispose
f
„
of in compliance with nationally
applicable regulations.

12. Accessories

For mounting aids and other accessories see www.baumer.com.
14 / 54
Temperature measurement
RTD temperature sensor
Cause
Sensor not correctly connected
Device error
Short circuit
Wrong cabling
Incorrect temperature range
Operating Instructions
Options with FlexProgram
Sensor type
„ „
Temperature unit
„ „
Temperature range
„ „
Output limit
„ „
Damping
„ „
Data Logging
„ „
Sensor offset
„ „
Automatic cable compensation
„ „
Action
Check plug and power supply.
f „
Dismount and send sensor to Baumer.
f „
Remedy short circuit.
f
„
Connect the display and the
f „
transmitter with the UnitCom cable.
Check programmed range limits.
f
„
Repair
Do not repair the sensor yourself.
Send damaged sensor to Baumer.
f „
www.baumer.com