Configuration - Baumer CombiTemp TFRH Manuel De Mise En Service

8.

Configuration

8.1 Configuring DFON touch screen
Tap on the display screen and hold until the menu button appears.
f „
Press menu to start the configuration.
f „
Example
Configure screen layout.
f „
Menu Display menu
Further possible settings:
Relays
„ „
Warning and error indication
„ „
Screen layout
„ „
Color
„ „
Language
„ „
8.2 Configuring transmitter via DFON touch screen
For TFRH/N with mounted FlexTop™ 2212 and FlexTop™ 2222 transmitters further configurations can be
programmed via DFON touch screen.
Tap on the display screen and hold until the menu button appears.
f „
Press menu to start the configuration.
f „
Example
Configure input range.
f
„
Menu FlexTop menu
Configure damping range.
f
„
Menu FlexTop menu
Further possible settings:
Sensor type
„ „
Temperature unit
„ „
Output limit
„ „
Sensor offset
„ „
8.3 Configuring transmitter via FlexProgram
DANGER
FlexProgrammer is not ATEX approved for use in explosive atmospheres
Do not use FlexProgrammer in explosive atmospheres.
f „
Configuring with FlexProgrammer and PC
Remove front cover/DFON display from TFRH/N.
f
„
Connect FlexProgrammer to FlexTop 2202.
f
„
Connect FlexProgrammer to PC and set
f
„
parameters (see FlexProgrammer instructions).
www.baumer.com
Display setup
Screen layout
Input config. Input range
Output config. Output damping
Operating Instructions
Temperature measurement
CombiTemp™ TFRH/N
RTD temperature sensor
FlexTop specific screens
Input at 4 mA
Input at 20 mA
Damping value
1
2
Select display design
Temp. value
Temp. value
13 / 54