Configuration; Operation - Baumer CleverLevel LBFS Manuel De Mise En Service

CleverLevel
9.

Configuration

The sensor can be configured with the
FlexProgrammer. This allows switching points
and damping values to be selected as required. In
addition pulse width modulation can be specified
for the signal.
Examples for pulse width modulation
U 10%
U 50%
U 75%

10. Operation

Standard operation with factory settings
BU
BU = blue: Switched output, active
„ „
LED does not light up: Switched output, inactive
„ „
Application-specific settings: see chapter "15. Factory settings and user settings" on page 16.
12 / 48
Level measurement
® LBFS
Point level detection
t
t
t
Operating Instructions
Configuring with FlexProgrammer and PC
Connect FlexProgrammer to sensor.
f
„
Connect FlexProgrammer to PC and set
f
„
parameters (see FlexProgrammer instructions).
Copying configuration with FlexProgrammer
Copy the configuration of one sensor to
f „
another sensor using FlexProgrammer (see
FlexProgrammer instructions)
1
2
LED indication for "Power-On"
BU
BU = blue: Switched output, active
„ „
GN = green: Switched output, inactive
„ „
A green LED can be activated indicating „Power-
On" by using the FlexProgrammer.
GN
www.baumer.com