Freestyle Libre 2 Manuel D'utilisation page 14

than the one most recently used.
2. Wash application site for at least 10 seconds using a plain soap and dry with
a towel. Make sure site is dry and then clean with an alcohol wipe. This will
help remove any oily residue that may prevent the Sensor from sticking
properly. Allow site to air-dry before proceeding.
Note: Note: The area MUST
site.
3. Open the Sensor Pack by peeling the lid off completely. Unscrew the cap
from the Sensor Applicator and set the cap aside.
CAUTION: CAUTION: Do NOT use if the Sensor Pack or Sensor Applicator seem to be
damaged or already opened. Do NOT use if past expiry date.
MUST be clean and dry, or the Sensor may not stick to the
ART41758-100_rev-A 3:14pm 18-JAN-2021