Prebena 1GP-ALK35 Notice Originale page 68

Faults
Symptom
30
Possible cause
The wrong fasteners
were loaded in the
magazine
The tacker is
insufficiently
lubricated.
The operating
pressure is too low.
The piston with the
driver does not return
to its initial position
after the drive-in
procedure.
The triggering
sequence is not
performed completely.
The driver is bent.
Corrective measure
 Empty the magazine.
 Fill the magazine with
PREBENA fasteners
(see page 17).
 Fill PREBENA special
nailer oil into the
compressed air
connection used.
 Actuate the trigger
several times.
 Increase the operating
pressure.
 Notify customer services
(see page 35).
 Notify customer services
(see page 35).
 Notify customer services
(see page 35).