Connecting The Tacker To The Compressed Air Supply - Prebena 1GP-ALK35 Notice Originale

Preparing the tacker
 Check the following points in particular:
-
The hose line must not be damaged.
-
All parts of the tacker and all accessory parts must be securely
attached.
-
The safety devices must not be blocked or otherwise impaired
in their function.
-
No parts of the tacker or the accessories may show visible
signs of damage, such as scratches or dents.
Scratches on the housing paint or the magazine do not

constitute damage.
 Do not connect a damaged tacker to a compressed air supply.
 Have a damaged tacker repaired by qualified staff before putting
it into operation.

Connecting the tacker to the compressed air supply

You can connect the tacker to a compressor or a compressed air
system.
Operation with a compressor or a compressed air system is only
permitted if the following preconditions are met:
 The operating pressure of the compressor or compressed air
system must not be more than 10% above the maximum
operating pressure of the tacker. Specifications on the operating
pressure of the tackers are provided in this section on page 14.
 On compressed air systems with higher pressure, a pressure
regulating valve (pressure reducer) with a downstream pressure
relief valve must be installed in the compressed air line.
 The compressed air must be filtered, dry and lubricated with
PREBENA special nailer oil.
 At the outlets for the compressed air line to the tacker, a
compressed air maintenance unit must be installed on the
coupling side. It should contain
-
a filter,
-
a water separator and
-
an oiler.
14