Opening The Magazine; Inserting Fasteners - Prebena 1GP-ALK35 Notice Originale

 In this case, immediately disconnect the compressed air
hose from the tacker.

Opening the magazine

 To open the magazine (6), push the locking mechanism (4)
forwards in the direction of the arrow.
 Pull out the lateral slider at the lock (5) towards the rear.

Inserting fasteners

 To insert the fasteners (14) in the magazine, tilt the tacker to the
side and insert the strips into the magazine with the crown
upwards (type: ALK).
 Make sure that the tip of the printed arrow (type: AL) on the
fastener is pointing downwards.
 Push the fasteners as far as they will go to the left into the inlet.
WARNING
Risk of explosion if the maximum operating
pressure is exceeded.
Preparing the tacker
17