Triggering The Tacker - Prebena 1GP-ALK35 Notice Originale

Operating the tacker
The driving depth of the fasteners depends on the hardness and
thickness of the piece of wood and the set operating pressure.
 Ensure that there are no persons behind the piece of wood.
 Then check the function of the tacker at a low operating pressure
by triggering it once.
 Regulate the operating pressure according to the strength of the
wood used.
The correct operating pressure is set when the required driving depth
of the fasteners is achieved at the lowest possible pressure.

Triggering the tacker

Proceed as follows to trigger the tacker once:
 Push the trigger lock (8) on the tacker at a right angle, but no
more than an angle of <30°, onto the piece of wood.
 Press the trigger (7).
A fastener is driven into the piece of wood.
 Release the trigger.
 Lift the tacker off the piece of wood.
 Repeat these steps to drive in further fasteners.
22