Triumph 400T Manuel Du Propriétaire page 7

ASSEMBLY STEp 3
HARdWARE bAG 3 CONTENTS :
BOLT (E) SPRING ARC
15 mm WASHER (F) WASHER (G)
Qty: 4 6 mm 6 mm
Qty: 2 Qty: 2
BOLT (H)
SPRING WASHER (B)
55 mm 8 mm
Qty: 4
Qty: 4
CONSOLE
CABLE
ASSEMBLE
SPRING WASHERS (F)
LEFT SIDE
FIRST
SPRING WASHERS (B)
12
400T-OM-rev1_1.indd 12-13
Open hardware bag 3.
A
ARC
B Slide each handlebar into the console
WASHER (D)
8 mm
and attach using 2 bolts (e), 2 spring
Qty: 4
washers (f) and 2 arc washers (g). Do
not completely tighten bolts until step D.
gently place the console on top of the
C
console masts. Attach the left side first
using 2 bolts (h), 2 spring washers (b)
and 2 arc washers (d).
Attach the right side of the console using
D
2 bolts (h), 2 spring washers (b) and 2
CONSOLE
arc washers (d). Completely tighten all bolts
HANDLEBAR
from steps B–D.
ARC WASHERS (G)
BOLTS (E)
NOTE: be careful not to pinch any
wires while attaching the console.
ARC WASHERS (D)
BOLTS (H)
CONSOLE MAST
ASSEMBLY STEp 3 CONTINUED
CONSOLE
CONSOLE MAST
CONSOLE CONSOLE
CABLE CABLE
COVER
PLASTIC CLIPS
BOLTS (E) HANDLEBAR
E Remove the console cable cover.
Connect the console cable and secure the
F
cable in the 2 plastic clips. Carefully tuck
excess cable in the console mast to avoid
damage.
Attach the console cable cover to secure
g
the console cable.
Secure the handlebars to the console
H
masts by inserting 2 bolts (e) from below the
console.
10/29/10 1:44 PM
13