Triumph 400T Manuel Du Propriétaire page 6

ASSEMBLY STEp 1
BOLT (A) SPRING WASHER (B)
20 mm 8 mm
Qty: 4 Qty: 4
715T PLUS
LEFT CONSOLE MAST
ARC WASHERS (D)
BOLTS (A)
SPRING WASHERS (B)
FLAT WASHERS (C)
BASE FRAME
10
400T-OM-rev1_1.indd 10-11
HARdWARE bAG 1 CONTENTS :
FLAT WASHER (C) ARC WASHER (D)
8 mm 8 mm
Qty: 2 Qty: 2
A Cut the yellow banding straps and lift the
running deck upward and remove all
contents from underneath the running deck.
Open hardware bag 1.
B
With the running deck lowered, attach
C
the left console mast to the base
frame using 2 bolts (a), 2 spring
washers (b) and 2 flat washers (c)
from the side and 2 bolts (a), 2 spring
washers (b) and 2 arc washers (d)
from the rear.
ASSEMBLY STEp 2
HARdWARE bAG 2 CONTENTS :
BOLT (A) SPRING WASHER (B)
20 mm 8 mm
Qty: 4 Qty: 4
LEAD WIRE
715T PLUS
RIGHT CONSOLE MAST
ARC WASHERS (D)
BOLTS (A)
SPRING WASHERS (B)
CONSOLE CABLE
FLAT WASHERS (C)
BASE FRAME
FLAT WASHER (C) ARC WASHER (D)
8 mm 8 mm
Qty: 2 Qty: 2
Open hardware bag 2.
A
Pull lead wire through right console
B
mast. After pulling the lead wire through the
mast, the top of the console cable should
be located at the top of the mast. Detach and
discard the lead wire.
With the running deck lowered, attach
C
the right console mast to the base
frame using 2 bolts (a), 2 spring
washers (b) and 2 flat washers (c)
from the side and 2 bolts (a), 2 spring
washers (b) and 2 arc washers (d)
from the rear.
NOTE: Be careful not to pinch any wires
while assembling the right console mast.
10/29/10 1:44 PM
11