Fein ABS18 Q Serie Mode D'emploi page 16

OBJ_BUCH-0000000311-001.book Page 16 Friday, May 4, 2018 9:20 AM
en
16
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Setting the operating mode.
Change the operating mode only when the power tool is switched off! Otherwise, the machine
can become damaged.
Always turn the operating mode selector switch to the stop. Otherwise, the machine can
become damaged.
ASB18 Q (**) (figure 8).
Set the desired operating mode.
– For drilling, set the operating mode selec-
tor switch to the "drilling" symbol.
– For screwdriving, set the operating mode
selector switch to the "screwdriving" sym-
bol.
– For hammer drilling, set the operating
mode selector switch to the "hammer
drilling" symbol.
Fig. 8