Precautions for Use
● More than one Touch Pen cannot be used at a time.
● Be careful not to allow sand or dust to come in contact with the Touch Pen.
If fine sand or dust enters the inside of the Touch Pen, malfunction may occur.
● Do not use the Touch Pen near a TV or Radio.
Image noise may appear on the TV screen or sound noise may be heard from the
radio.
● Do not use the Touch Pen where a strong radio wave or magnetism is present.
Using it near such locations as a broadcasting tower or electric appliances with a
built-in motor may cause improper operation of the Touch Pen.
● Do not use the Touch Pen where corrosive gas is present .
Using it where corrosive gases such as hydrogen sulfide gas or exhaust gas of
gasoline engine, diesel engine, etc. are present may cause the internal parts to
corrode, resulting in malfunction.
● Do not use the Touch Pen near a humidifier.
E
Allowing moisture to enter the inside of the Touch Pen may cause improper
operation due to condensation.
● Attention needs to be paid to environmental temperature.
• Using the Touch Pen where it is extremely hot or cold may cause improper
operation.
• Leaving the Touch pen in a closed car, etc. for a long period of time may cause
malfunction.
● Do not use the Touch Pen at a place with much oily smoke or steam.
Doing so may lead to product deformation or malfunction.
Storage and Maintenance
● Avoid storing the Touch Pen in hot or highly humid locations.
● Clean using a soft and dry cloth. If dust, etc. is attached to the soft cloth, the
product may be scratched. Wipe the dust away before using. Do not use benzene,
thinner, or wax on the Touch Pen. Doing so may cause the paint to peel off.
● Do not dunk the Touch Pen in liquid such as water when cleaning.
● Remove soil stuck to the pen tip with a cotton swab, etc. Be careful not to subject
the pen tip to impact since it is equipped with the sensor. Using the Touch Pen with
soil or foreign matters attached may cause scratch of the screen.
● Protect the pen tip with the supplied pen cap when not using.
4