Panasonic UT-VNP5000WU Instructions D'utilisation page 13

Operation example
Hold/Release
Drag and drop
● Hold a part near the button of Touch Pen.
● Use the pen tip to perform screen operation or select an item.
● If the tilting angle is too large or the pen tip is pushed in, the operation may not be normal.
● The Touch Pen may not operate normally if input operation using the Touch Pen is
performed with your hand placed on the screen.
● Connect the charging cable when using long hours.
● Do not move the pen with its pen tip pressed down strongly on the screen or move
it fast on the screen.
● Wrong use may scratch the screen.
Power-off mode
Turn off the electric wave of the Touch Pen according to the following procedure.
Set the Touch Pen to the Power-off Mode when not using for a long period of time, etc.
Set to Power off also when bring it on a plane.
1
Press the pen tip to the screen, etc. and press and hold the
Button 1 and Button 2 simultaneously for 5 seconds or more.
● The display become turned off.
● To turn on the touch pen, perform step 1 again.
Updating the driver
See the following FAQ and download the latest driver.
http://pc-dl.panasonic.co.jp/itn/
Replacing the Tip
If the core of pen tip wears or operation is not smooth, replace the pen tip. See below
for replacement procedure.
NOTE
● The supplied replacement tips is exclusively for use with this Touch pen,
and should not be used with other pens, etc.
● If the tip becomes too short, it may be difficult to pull out. Replace the tip
before it becomes too short.
How to move
Keep touching the pen tip to
the panel/Release the pen tip.
Move with the pen tip
touched to the panel.
Description
Select the item and hold/Release
the selection of the item.
Move with the item selected.
E
13