Panasonic CF-VWLS071 Mode D'emploi page 19

Windows NT (When Card Executive™ has not been installed)
<When setting the network for the first time>
1
Select [Control Panel]-[Network].
2
At [Network Configuration], select [Yes].
3
At [Network Setup Wizard], add the checkmark for [Wired to the network], then
select [Next].
4
Select [Select from list].
5
When [Select Network Adapter] is displayed, select [Have Disk].
6
Input [L:\wlan\winnt] and select [OK].
7
Select [WLAN PC Card], then select [OK].
8
Confirm the check mark is added for [WLAN PC Card], then select [Next].
9
Add the check mark for [TCP/IP Protocol], then select [Next].
10
Confirm the checked network service, then select [Next].
When using except the displayed network service, select [Select from list].
11
Select [Next].
12
Input [C:\winnt\i386] and select [Continue].
13
Select [No].
14
At [Microsoft TCP/IP Properties], set the settings confirmed by the system admin-
istrator, then select [OK], and then select [Next].
15
Select [Next].
16
Select [Next].
17
Select [Finish].
18
Select [Yes].
The computer will restart.
19
Set the Wireless LAN Card to the PC Card slot.
<When the network has been set>
1
Select [Control Panel]-[Network].
2
At [Network], select [Adapters].
3
Select [Add].
4
When [Select Network Adapter] is displayed, select [Have Disk].
5
Input [L:\wlan\winnt] and select [OK].
6
Select [WLAN PC Card], then select [OK].
7
Confirm the check mark is added for [WLAN PC Card], then select [Close].
8
At [Microsoft TCP/IP Properties], set the settings confirmed by the system admin-
istrator, then select [OK].
9
Select [Yes].
The computer will restart.
10
Set the Wireless LAN Card to the PC Card slot.
E
19